MINES AND MINING PLANTS, R.R.O. 1990, Reg. 854
Section 202
Cite as MINES AND MINING PLANTS, R.R.O. 1990, Reg. 854, s. 202 · current to November 11, 2026 · consolidated from July 1, 2025 · read from e-Laws on November 16, 2026
The text
(1) Standard practices to govern the safe operation of a standard gauge railroad, a self-propelled track crane, motorized equipment used for the maintenance of a standard gauge railroad, a motor vehicle equipped with rail wheels in addition to rubber-tired wheels or other similar equipment shall be prepared in writing. R.R.O. 1990, Reg. 854, s. 202 (1).
(2) A copy of the standard practices prepared in accordance with subsection (1) shall be provided to each railroad worker and each railroad worker,
(a) shall be trained and instructed in and be knowledgeable of the standard practices for his or her work; and
(b) shall have a copy of the standard practices readily available while on duty. R.R.O. 1990, Reg. 854, s. 202 (2).
(3) Where a railroad of a mine or mining plant interconnects with a railroad of a railway company a standard procedure shall be established and followed for carrying on operations on the first mentioned railroad. R.R.O. 1990, Reg. 854, s. 202 (3).
(4) A railroad shall be built to safely withstand speeds and loads to which it will normally be subjected by a train. R.R.O. 1990, Reg. 854, s. 202 (4).
(5) A low bridge warning sign shall be installed at an approach of a railroad to an overhead structure, where the clearance between the underside of the structure and the top of any railroad car is less than two metres. R.R.O. 1990, Reg. 854, s. 202 (5); O. Reg. 34/14, s. 13.
(6) Guard rails shall be placed at the approach to railroad tracks where the view is obstructed in one or both directions. R.R.O. 1990, Reg. 854, s. 202 (6).
(7) A locomotive shall,
(a) have an audible warning system in proper working condition;
(b) have a suitable headlight for each travel direction when operating in areas without adequate lighting;
(c) be equipped with brakes in proper working condition; and
(d) have the control lever so mounted as to prevent its inadvertent removal. R.R.O. 1990, Reg. 854, s. 202 (7).
(8) The locomotive operator shall be in position at the controls when operating the locomotive on manual control. R.R.O. 1990, Reg. 854, s. 202 (8).
(9) Before leaving a locomotive unattended, the operator shall,
(a) set the controls in position for parking;
(b) set the brakes; and
(c) on a grade, use hand brakes or wheel chocks to prevent movement of the locomotive. R.R.O. 1990, Reg. 854, s. 202 (9).
(10) The owner shall give notice to the joint health and safety committee or the health and safety representatives, if any, before installing remote or automatic controls for the operation of a locomotive. O. Reg. 272/97, s. 36.
(11) A standard practice shall be prepared for the use of radio communications systems on a railroad. R.R.O. 1990, Reg. 854, s. 202 (11).
(12) Only authorized persons shall ride on a train. R.R.O. 1990, Reg. 854, s. 202 (12).
(13) One or more workers shall be stationed to direct the operator of a locomotive when backing a train in a location where persons may be endangered. R.R.O. 1990, Reg. 854, s. 202 (13).
(14) A car shall not be permitted to run free unless,
(a) adequate control thereof is maintained; and
(b) there is no hazard to a worker. R.R.O. 1990, Reg. 854, s. 202 (14).
Read the MINES AND MINING PLANTS on e-Laws ↗
Made under Occupational Health and Safety Act, R.S.O. 1990, c. O.1.