PORTABLE TRAFFIC CONTROL SYSTEMS, O. Reg. 185/22

Section 9

Gate arm

Cite as PORTABLE TRAFFIC CONTROL SYSTEMS, O. Reg. 185/22, s. 9 · current to November 11, 2026 · consolidated from April 1, 2022 · read from e-Laws on November 16, 2026

The text

(1) The gate arm of an automated flagger assistance device shall meet the following criteria: 1. The gate arm must be at least two metres long and at least 10 centimetres wide. 2. The gate arm must be covered on both sides with alternating vertical contrasting stripes. At least one set of stripes must be made of retro-reflective sheeting. 2. The gate arm must be covered on both sides with alternating vertical stripes of orange and black. The orange stripes must be made of retro-reflective sheeting. 3. When lowered, the bottom edge of the gate arm must be not less than 110 centimetres but not more than 140 centimetres above the level of the roadway. (2) Figure 4 is an illustration of an automated flagger assistance device that meets the requirements set out in this section and sections 7 and 8. Figure 4
Read the PORTABLE TRAFFIC CONTROL SYSTEMS on e-Laws ↗

Made under Highway Traffic Act, R.S.O. 1990, c. H.8.