REGISTRATIONS UNDER PART II.2 OF THE ACT - END-OF-LIFE VEHICLES, O. Reg. 85/16

Section 7

Activity requirements, s. 20.21 (1) (c) of the Act - waste

Cite as REGISTRATIONS UNDER PART II.2 OF THE ACT - END-OF-LIFE VEHICLES, O. Reg. 85/16, s. 7 · current to November 11, 2026 · consolidated from September 30, 2017 · read from e-Laws on November 16, 2026

The text

(1) For the purposes of clause 20.21 (1) (c) of the Act, a person who engages in an activity prescribed by paragraph 1 of subsection 4 (1) of this Regulation shall ensure that the following requirements are complied with: 1. All fluids shall be removed and collected from all material that is permitted to be managed at an end-of-life vehicle waste disposal site prior to shearing, crushing or shredding the material. 2. The fluids referred to in paragraph 1 shall be removed as follows: i. On an impermeable surface that has a spill containment system. ii. Under a covered structure and in such a manner so as to prevent precipitation from coming into contact with the fluids or the components from which the fluids are being removed. 3. All shearing, crushing and shredding equipment shall meet at least one of the following requirements: i. The equipment must have a spill containment system. ii. The equipment must be used and operated in an area with a spill containment system. 4. All batteries that have been removed and collected from an end-of-life vehicle shall be stored in such a manner so as to prevent the following: i. Precipitation from coming into contact with the battery. ii. Short circuiting of the battery. 5. All electrical switches that contain mercury, battery cable connectors that contain lead and tire weights that contain lead that have been removed and collected from an end-of-life-vehicle and all fluids that have been removed from a material that is permitted to be managed at an end-of-life vehicle waste disposal site shall be stored in separate containers that meet the following requirements: i. The container is stored above ground. ii. The container bears a label on which the contents of the container are clearly identified. iii. The container is designed or protected in such a manner so as to prevent precipitation from coming into contact with the contents of the container. iv. The container is capable of storing its contents without any degradation or deterioration of the container or any leaks. v. If the contents of the container are fluids or electrical switches that contain mercury, the container is closed and sealed when not in active use. 6. All batteries that have been removed and collected from an end-of-life vehicle and the materials referred to in paragraph 5 that have been removed and collected from a material that is permitted to be managed at an end-of-life vehicle waste disposal site must not be stored for a period exceeding 24 months. 7. The fluids referred to in paragraph 5 that have been removed from a material that is permitted to be managed at an end-of-life vehicle waste disposal site must be stored, handled and maintained so as to prevent the following: i. Leaks or spills of the fluid. ii. Damage to or deterioration of the container in which the fluid is stored. 8. If a wet component has been removed and collected from an end-of-life vehicle, it shall be stored as follows: i. On an impermeable pad. ii. In such a manner so as to prevent precipitation from coming into contact with the component. 9. The person shall develop and implement a spill prevention and management plan with respect to the end-of-life vehicle waste disposal site that includes, at a minimum, the following: i. The procedures and materials to be used for the clean-up of a spill. ii. The location of all drains. iii. The location of materials that may be used to temporarily seal drains in the event of a spill. iv. The names of the persons to be notified in the event of a spill. v. The schedule for inspecting the storage areas, containers and spill containment systems. 10. Materials that have been used in the operation of the end-of-life vehicle waste disposal site or that have been or will be used to clean up spills at the site shall be stored in sealed containers prior to disposal and when not in use. 11. Every employee of an operator of an end-of-life vehicle waste disposal site and every person retained by the operator who engages in the management of a material that is permitted to be managed at an end-of-life vehicle waste disposal site shall have received training with respect to the following: i. Waste management legislation, regulations and guidelines that are relevant to the operation of an end-of-life vehicle waste disposal site. ii. Environmental concerns pertaining to a material that may be handled at an end-of-life vehicle waste disposal site. iii. Occupational health and safety concerns pertaining to a material that may be handled at an end-of-life vehicle waste disposal site. iv. The safe use and operation of equipment that may be used or operated at an end-of-life vehicle waste disposal site. v. Procedures for responding to emergencies, including fires and explosions, that may occur at an end-of-life vehicle waste disposal site. vi. Procedures for dealing with spills that may occur at an end-of-life vehicle waste disposal site, including clean up, disposal and reporting procedures. 12. All storage areas and containers are inspected for spills and leaks at least once a week by a person who has received the training described in paragraph 11. 13. If the person receives a complaint with respect to the end-of-life vehicle waste disposal site and the complaint relates to the natural environment, the district manager of the Ministry for the district in which the events leading to the complaint are alleged to have occurred shall be notified no later than two business days after the complaint is received. 14. Any equipment used or operated at the end-of-life vehicle waste disposal site to shear or crush a material that is permitted to be managed at the site shall be used or operated only between the hours of 7 a.m. and 7 p.m. 15. Any equipment that is used to shear or crush a material or mechanically remove fluids from a material that is permitted to be managed at the end-of-life vehicle waste disposal site shall be used, operated and maintained in a manner that satisfies the recommendations of the manufacturer of the equipment. 16. Access to the end-of-life vehicle waste disposal site shall be limited to such times as an attendant is on duty who is trained in the matters described in paragraph 11. 17. Subject to subsection (2), the total number of tire units stored on the property upon which the end-of-life waste disposal site is situated shall be less than 5,000 and the total volume of all stored piles of tire units on the property shall be less than 300 cubic metres. (2) The requirement set out in paragraph 17 of subsection (1) does not apply if an environmental compliance approval provides otherwise. (3) For the purposes of paragraph 17 of subsection (1), a tire unit has the same meaning as in subsection 6 (1) of Regulation 347 of the Revised Regulations of Ontario, 1990 (General – Waste Management) made under the Act.
Read the REGISTRATIONS UNDER PART II.2 OF THE ACT - END-OF-LIFE VEHICLES on e-Laws ↗

Made under Environmental Protection Act, R.S.O. 1990, c. E.19.