SECURITY OF LOADS, O. Reg. 363/04
Section 6
Tiedowns
Cite as SECURITY OF LOADS, O. Reg. 363/04, s. 6 · current to November 11, 2026 · consolidated from July 1, 2012 · read from e-Laws on November 17, 2026
The text
(1) The working load limit of a tiedown shall be deemed to be the working load limit of its weakest component. O. Reg. 363/04, s. 6 (1).
(2) Revoked: O. Reg. 165/12, s. 3.
(3) The strength of anchor points must be at least as strong as the tiedown when the connector is loaded in any direction in which the tiedown may load it. O. Reg. 363/04, s. 6 (3).
(4) A tiedown shall not be used if,
(a) the active portion has knots in it;
(b) any component of it exhibits stretch, deformation, wear or damage beyond the limits specified by the manufacturer; or
(c) it has been repaired or shortened other than in accordance with the manufacturer’s specifications. O. Reg. 363/04, s. 6 (4).
(5) Where an “over-the-centre” type of tiedown tensioner is used, the handle must be locked in place and secured by an adequate secondary means to prevent its inadvertent release. O. Reg. 363/04, s. 6 (5).
(6) Except in the case of steel, fibre or synthetic strapping that is permanently crimped, tiedowns used on a commercial motor vehicle to secure the load against movement in any direction must be designed, constructed and maintained in such a manner that the driver of the vehicle can tighten the tiedown in transit. O. Reg. 363/04, s. 6 (6).
Read the SECURITY OF LOADS on e-Laws ↗
Made under Highway Traffic Act, R.S.O. 1990, c. H.8.