general, O. Reg. 267/03

Section 43

Non-agricultural source materials, October 1 to June 14

Cite as general, O. Reg. 267/03, s. 43 · current to November 11, 2026 · consolidated from April 1, 2024 · read from e-Laws on November 16, 2026

The text

(1) This section applies during the period that begins on October 1 in any year and ends on June 14 of the following year. O. Reg. 338/09, s. 43. (2) No person shall apply liquid non-agricultural source materials to an area, (a) if the runoff potential for the area shown on the Table to subsection (3) shows that no application is allowed; (b) at a rate in excess of that determined under the Table to subsection (4); or (c) if the maximum sustained slope of the area is 12 per cent or greater. O. Reg. 338/09, s. 43. (3) The runoff potential of land for a hydrologic soil group set out in Column 1 of the following Table is set out in Columns 2, 3 or 4 opposite it where a liquid NASM is applied to an area with a maximum sustained slope described in the heading of Columns 2, 3 or 4. Table Runoff Potential Column 1 Hydrologic soil group | Column 2 Maximum sustained slope of at least 3% but less than 6% | Column 3 Maximum sustained slope of at least 6% but less than 9% | Column 4 Maximum sustained slope of at least 9% but less than 12% A | Very low | Low | High B | Low | Moderate | High C | Moderate | High | No application allowed D | High | High | No application allowed (4) The maximum rate within a 24-hour period for the application of liquid NASM to an area, in the case of an area for which the runoff potential is set out in Column 1 of the following Table, is set out, (a) in Column 2 opposite it, if the materials are applied to the surface of the area; (b) in Column 3 opposite it, if the materials are injected or incorporated into the area or if the area is pre-tilled: TABLE maximum application rate Column 1 Runoff potential of land | Column 2 Maximum rate of application within 24-hour period if materials are applied to surface of area, in cubic metres per hectare | Column 3 Maximum rate of application within 24-hour period if materials are injected or incorporated into area or if area is pre-tilled, in cubic metres per hectare High | 50 | 75 Moderate | 75 | 100 Low | 100 | 130 Very low | 130 | 150 (5) For the purposes of subsection (4), materials are incorporated into an area only if they are incorporated into it within 24 hours of being applied. O. Reg. 338/09, s. 43. (6) For the purposes of subsection (4), an area is pre-tilled only if the tillage occurred not more than seven days before the application of the liquid NASM. O. Reg. 338/09, s. 43.
Read the general on e-Laws ↗

Made under Nutrient Management Act, 2002, S.O. 2002, c. 4.