Fuel Industry Certificates, O. Reg. 215/01

Section 22

G.3 certificate

Cite as Fuel Industry Certificates, O. Reg. 215/01, s. 22 · current to November 11, 2026 · consolidated from January 1, 2022 · read from e-Laws on November 16, 2026

The text

(1) A person who is the holder of a G.3 certificate may, under the general supervision of a person who is the holder of a G.1, G.2 or DA certificate, carry out the following functions on a propane or natural gas appliance that fall within the scope of the supervising certificate holder’s certificate, but only if the person has demonstrated the essential skills required to perform such work and has had that experience documented and signed-off by the supervising certificate holder in a form as set out and published by the director: 1. Install, test, activate or purge gas piping or tubing that is less than two and one-half inches in diameter or a component in a piping or tubing system to an appliance downstream of a natural gas meter or propane service valve up to an appliance control valve including the completion of the pressure test tag. 2. Reactivate a previously installed or converted appliance. 3. Clean and lubricate an appliance. 4. Clean, remove or replace a vent connector, venting or a draft control device. O. Reg. 215/01, s. 22 (1); O. Reg. 253/08, s. 14 (1). (2) A person referred to in subsection (1) shall not perform the initial activation of a new appliance or a newly converted appliance. O. Reg. 215/01, s. 22 (2). (3) Revoked: O. Reg. 253/08, s. 14 (2). (4) A person who is the holder of a G.3 certificate may, under the direct supervision of a person who is the holder of a G.1, G.2 or DA certificate, carry out any of the functions that fall within the scope of the supervising certificate holder’s certificate. O. Reg. 215/01, s. 22 (4).
Read the Fuel Industry Certificates on e-Laws ↗

Made under Technical Standards and Safety Act, 2000, S.O. 2000, c. 16.