Elevating Devices, O. Reg. 209/01
Section 45
Removal and replacement of seals
Cite as Elevating Devices, O. Reg. 209/01, s. 45 · current to November 11, 2026 · consolidated from July 1, 2022 · read from e-Laws on November 16, 2026
The text
(1) Where an inspector has sealed a part on an elevating device as part of an investigation or, subject to subsection (2), to prevent readjustment of the part, no person shall remove the seal without the permission of the inspector. O. Reg. 252/08, s. 25.
(2) A contractor may remove a seal without the permission of the inspector and may affix a replacement seal if,
(a) the contractor repairs or replaces a part that was sealed and the part’s settings remain at the setting at which the part was originally sealed or are returned to that setting; or
(b) the contractor changes the settings of the part that was sealed but the new settings are within the allowable range specified by the applicable code, standard or other requirement referred to in the code adoption document. O. Reg. 252/08, s. 25.
(3) Where an original seal is missing from a part, a contractor may, subject to subsection (5), affix a replacement seal provided that the settings of the replacement part remain the same as they were for the original part. O. Reg. 252/08, s. 25.
(4) A contractor who affixes a replacement seal under this section shall ensure that a permanent record is kept, either attached to the seal or adjacent to the seal, that gives,
(a) the date of replacement of the seal;
(b) the name, signature and certificate number of the mechanic who replaced the seal;
(c) the number of the replacement seal; and
(d) the setting at which the part is sealed. O. Reg. 252/08, s. 25.
(5) In addition to the record, the contractor shall record that the seal has been replaced in the log book referred to in section 34. O. Reg. 252/08, s. 25.
Read the Elevating Devices on e-Laws ↗
Made under Technical Standards and Safety Act, 2000, S.O. 2000, c. 16.