General, N.B. Reg. 91-191

Section 105

Weatherproofing of roof

Cite as General, N.B. Reg. 91-191, s. 105 · current to June 30, 2026 · read from New Brunswick Acts and Regulations on November 16, 2026

The text

(1) An employer and a contractor shall each ensure that a warning line is (a) not less than 2 m from the unguarded edge, (b) has a minimum diameter of 10 mm, (c) is suspended at a height of not less than 750 mm and not more than 900 mm, (d) is supported by corner and intermediate posts sufficient to keep the line taut, and (e) has readily visible markers placed every 1.5 m along the length of the line. (2) Despite paragraph (1)(a), a warning line may be 1 m from an unguarded edge at the dump point for snow removal or when an employee is engaged in weatherproofing, provided adequate precautions are taken to ensure the safety of the employee. (3) An employer shall ensure that an employee who is working in the control zone uses another method of fall-protection in addition to the warning line. (4) When employees are engaged in weatherproofing, a safety monitor may be used as the means of fall-protection for employees working in the control zone. (5) The safety monitor referred to in subsection (4) shall ensure that tasks being performed in the control zone are performed in accordance with the fall-protection code of practice and in a manner that minimizes the potential for an employee to fall. (6) A safety monitor referred in subsection (4) shall (a) be experienced in the work overseen and trained in the role of safety monitor, (b) be present at all times when an employee is in the control zone, (c) have complete authority over the work as it relates to the prevention of falls, (d) be located so as to have a clear view of the work being performed by the employee, (e) be able to communicate with the employees being protected without needing to yell, (f) be instantly distinguishable from other workers, (g) engage in no other duties while acting as the safety monitor, and (h) monitor a maximum of eight workers. (7) An employer shall ensure that no employee enters the control zone unless the employee is required to do so by reason of the employee’s work duties. (8) The owner of a place of employment, employer and contractor shall each ensure a travel restraint system (a) is rigged to prevent the employee from reaching an unguarded edge, (b) is, subject to paragraph (c), attached to an anchor point capable of supporting two times the maximum load likely to be applied to it, or (c) when it is used on a roof with a slope greater than 3 in 12, is attached to an anchor point that is capable of withstanding a 22 kN force or, if used under the direction of a competent person, four times the maximum load that may be generated in the fall-arresting system.
Read the General on the Province's website ↗

Made under Occupational Health and Safety Act, c. O-0.2.