Water Well, N.B. Reg. 90-79
Section 16
Cite as Water Well, N.B. Reg. 90-79, s. 16 · current to June 13, 2012 · read from New Brunswick Acts and Regulations on November 16, 2026
The text
(1) No well shall be drilled unless the well driller installs casing in standard pipe size and weight in accordance with Schedule A, which casing shall
(a) be made of new material,
(b) be of sufficient length, but at least six metres long, unless exempted by the Minister,
(c) be properly welded or connected where required to prevent contamination of water in the well,
(d) have an inside diameter that is at least 12.7 centimetres unless exempted by the Minister, and
(e) have welded or threaded on the end in contact with the soil or rock an appropriate sized drive shoe suitable for providing a seal with the adjacent formation.
(2) If compliance with subsection (1) does not prevent contamination of the water in the well, the well contractor shall
(a) firmly seat the casing in bedrock at a depth specified by the Minister,
(b) surround the casing with a cement grout that is not less than sixty millimetres in thickness, and
(c) carry out such remedial action as the Minister may determine.
(3) Immediately after a well has been completely constructed, a well driller shall thoroughly clean all debris from the well and shall disinfect the well using a method approved by the Minister before construction.
(4) Where the drilling and disinfection of a well has been completed, a well driller shall seal the upper open end of the casing with a well seal of a type approved by the Minister in such a manner as to prevent contamination of the well before a pump is installed.
Read the Water Well on the Province's website ↗
Made under Clean Water Act, c. C-6.1.