Commercial Vehicle Massing, N.B. Reg. 83-199
Section 5
Using approved portable platform massing devices
Cite as Commercial Vehicle Massing, N.B. Reg. 83-199, s. 5 · current to July 31, 2015 · read from New Brunswick Acts and Regulations on November 16, 2026
The text
(1) To mass vehicles and axles by using approved portable platform massing devices, a qualified technician shall
(a) direct the operator or person having care or control of the vehicle to stop the vehicle at a location that is within plus or minus two per cent of a level grade in the longitudinal direction of the vehicle,
(b) ensure that each approved portable platform massing device is properly adjusted to zero reading,
(c) direct the operator or the person having care or control of the vehicle to drive the vehicle onto the approved portable platform massing devices,
(d) mass an axle or axle group of the vehicle,
(e) repeat any of the steps set out in paragraphs (a) to (d) that may be necessary to mass all of the axles or groups of axles of the vehicle, and
(f) add the masses indicated by the approved portable platform massing devices to determine the total mass of
(i) an axle,
(ii) an axle group, or
(iii) the entire vehicle.
(2) When determining the mass of a vehicle and its axles by using approved portable platform massing devices, a qualified technician may use in addition to those devices, approved portable wheel massing devices.
Read the Commercial Vehicle Massing on the Province's website ↗
Made under Motor Vehicle Act, c. M-17.