General, N.B. Reg. 83-190

Section 60

Cite as General, N.B. Reg. 83-190, s. 60 · current to May 15, 2018 · read from New Brunswick Acts and Regulations on November 16, 2026

The text

(1) To scale primary forest products in board feet, a scaler shall measure and record the length of a primary forest product in feet and the diameter of the top end, inside bark, in inches. (2) A scaler shall, unless otherwise specified in a contract, measure the length of a log from the point of any scarf and record to the nearest full foot. (3) Any log having a length greater than those lengths prescribed by Appendix M shall be scaled as two or more logs with a taper of one inch per eight feet of length. (4) A scaler shall measure the diameter inside the bark and record the diameter to the last full inch after dropping all fractions. (5) Subject to subsection (6), a scaler shall measure the diameter consistently with the scaling stick held either horizontally, vertically or at any angle without attempting to determine the smallest diameter. (6) If the surface to be measured is abnormally shaped with a difference of two inches or more between two inside bark diameters taken at right angles, the scaler shall record the mean diameter to the last full inch. (7) A scaler shall determine the board foot volume of logs from the table contained in Appendix M. (8) A scaler may require primary forest products that are to be scaled in board feet and that have no clear space at each end, to be unloaded and repiled before a scale is completed.
Read the General on the Province's website ↗

Made under Scalers Act, 2011, c.219.