General, N.B. Reg. 83-190

Section 57

Cite as General, N.B. Reg. 83-190, s. 57 · current to May 15, 2018 · read from New Brunswick Acts and Regulations on November 16, 2026

The text

(1) When scaling primary forest products by the cubic metre, a scaler shall make deductions for those defects which show on either or both ends of the piece, unless otherwise specified in a contract. (2) A scaler shall measure the diameter of a defect, or the average of two diameters if the defect is irregular, and record the measurements in 2-cm units. (3) A scaler may calculate the deduction for a defect by (a) subject to subsection (4) measuring the diameter of the defect in 2-cm units, estimating the length of the defect in 0.5-m units and then determining the deduction from the table contained in Appendix L, (b) applying a percentage reduction, or (c) such other methods as may be specified in a contract. (4) Where the diameter of a defect is not contained in Appendix L, a scaler shall calculate the volume of the defect in the primary forest product in accordance with the formula and method prescribed by Appendix L. (5) Unless otherwise specified in a contract, a scaler shall not make deductions for (a) checks or splits, crook, sweep or other irregularities in form, (b) worm holes, (c) abnormal discolourations that are not due to rot, or (d) red stain. (6) For all primary forest products, rot is a defect. (7) Repealed: 2014-19 (8) Where more than one-half of the gross volume of a log is defective by rot, a deduction equal to the total gross volume of the log shall be made. (9) When scaling treelengths to determine the cubic metre volume by the smallest butt diameter method, a scaler shall make deductions for defects (a) by determining the net volume from the appropriate treelength cubic metre volume table which the Minister approves; (b) by applying a percentage reduction; or (c) by such other method as may be specified in a contract.
Read the General on the Province's website ↗

Made under Scalers Act, 2011, c.219.