General, N.B. Reg. 83-190
Section 26
Cite as General, N.B. Reg. 83-190, s. 26 · current to May 15, 2018 · read from New Brunswick Acts and Regulations on November 16, 2026
The text
(1) The scale of any primary forest products in cubic metres may be either complete or partial.
(2) Where a scaler undertakes a partial scale, the scaler shall measure the diameter and length of a sufficient number of pieces until satisfied that the measures are representative of all the lengths and diameters in the pile.
(3) Where a scaler undertakes a partial scale, cull pieces shall be included in the calculation of average volume per piece.
(4) A scaler shall measure the diameter of each piece in a pile through the geometric centre of the piece.
(5) A scaler shall scale logs by measuring the smallest top diameter inside bark in 2-cm units and the length in 0.20-m units.
(6) A scaler shall determine the volume of softwood logs from the table contained in Appendix H.
(7) A scaler shall determine the volume of hardwood logs from the table contained in Appendix I.
(8) Logs that are longer than a specified length class shall be scaled as belonging to the next larger length class.
(9) A scaler shall scale weir stakes, poles, posts and pilings by measuring the smallest top diameter in 2-cm units and the length in 0.6-m units, and using those measurements shall determine the volume of weir stakes and spruce, tamarack, jack pine, red pine poles, posts and pilings from the table contained in Appendix J and the volume of cedar poles and posts from the table contained in Appendix K.
Read the General on the Province's website ↗
Made under Scalers Act, 2011, c.219.