Milk Quality, N.B. Reg. 2010-19
Section 16
Design and construction
Cite as Milk Quality, N.B. Reg. 2010-19, s. 16 · current to January 30, 2023 · read from New Brunswick Acts and Regulations on November 16, 2026
The text
(1) A producer shall have a farm bulk tank and shall ensure that the farm bulk tank
(a) is located in the producer’s milk house,
(b) has a holding capacity that is equivalent to a minimum of 2.5 days of milk production by the herd during its peak production period,
(c) is equipped with an indicating thermometer with scale divisions of at least 3 millimetres from each change of 2°C within a range of temperature of not less than 0°C and not more than 50°C that measures accurately to within 1°C of the actual temperature of the raw milk in the farm bulk tank,
(d) has mechanical agitation capable of restoring uniformity of all milk constituents throughout the farm bulk tank without splashing or churning the raw milk,
(e) does not use air agitation,
(f) is equipped with intermittent controlled agitation that provides a minimum of 5 minutes of agitation every hour,
(g) is equipped with refrigeration facilities capable of cooling the maximum capacity of raw milk obtained directly from the herd to a temperature of 4°C or lower within one hour of milking, and capable of maintaining raw milk at that temperature at all times except for the subsequent addition of raw milk obtained directly from the herd at which time the temperature of the raw milk shall not exceed 10°C,
(h) is equipped with an outlet cap,
(i) is equipped with adjustable support legs capable of
(i) supporting the weight of the farm bulk tank when filled to capacity,
(ii) adjusting the farm bulk tank to a level position, and
(iii) raising the farm bulk tank high enough for the attachment of fittings and for draining the farm bulk tank,
(j) is equipped with leg sockets with the outsides painted or made of corrosion resistant material,
(k) is installed and calibrated to provide an accurate measurement of the raw milk in the farm bulk tank,
(l) is installed so that the outlet valve has easy access to the hose port,
(m) is capable of properly cooling and agitating the raw milk from the first milking during the periods of lowest production of the herd,
(n) is equipped with a gauge rod which is plainly marked with graduation marks not further than one millimetre apart beginning at the bottom of the gauge rod,
(o) has a fixed point for the suspension of the gauge rod,
(p) has a conversion chart which shows the number of litres of raw milk for each graduation mark of the gauge rod,
(q) has the gauge rod and conversion chart stamped with serial numbers identical to the serial numbers on the farm bulk tank,
(r) has a smooth inside lining, and that all parts of the farm bulk tank that come in contact with raw milk are made of stainless steel, are free from cracks, rough welds, rough solder or open seams and are resistant to damage from cleansers and sanitizers,
(s) has the inside lining of its bottom sloped to an outlet so as to provide for complete drainage,
(t) has a stainless steel outlet valve, and
(u) if the farm bulk tank has a sight glass, the sight glass shall be maintained in good condition.
(2) If a farm bulk tank is welded or soldered and the repaired surface comes in contact with the raw milk,
(a) the metal used in the weld or solder shall be corrosive resistant stainless steel, and
(b) the weld or solder shall be ground smooth and polished so that it is flush with the adjoining surface.
(3) If a farm bulk tank is equipped with a time temperature recorder, the thermometer must be accurate to within 1°C of the actual temperature of the raw milk in the farm bulk tank, and the bulk tank milk grader shall have access to the recorded temperature of the raw milk.
Read the Milk Quality on the Province's website ↗
Made under Natural Products Act, c. N-1.2.