Milk Quality, N.B. Reg. 2010-19
Section 10
Design and construction
Cite as Milk Quality, N.B. Reg. 2010-19, s. 10 · current to January 30, 2023 · read from New Brunswick Acts and Regulations on November 16, 2026
The text
(1) A producer shall have a milk house and shall ensure that the milk house
(a) permits the installation of a farm bulk tank with a minimum distance of 15 centimetres between the exterior underside of the farm bulk tank and the milk house floor, unless the farm bulk tank has a rounded bottom, in which case the minimum distance shall be 10 centimetres,
(b) allows complete access to the farm bulk tank for inspection, cleaning and sanitizing and for the transfer of raw milk,
(c) has a ceiling that is high enough to permit the inspection of the raw milk in the farm bulk tank and the complete vertical removal of the gauge rod from the farm bulk tank,
(d) has a minimum passageway of 90 centimetres between the farm bulk tank and the sinks and utensil racks,
(e) has a minimum passageway of 60 centimetres around the sides and back of the farm bulk tank and a minimum passageway of 90 centimetres along the front end of the farm bulk tank,
(f) is equipped with a pressurized hot and cold running potable water system
(i) with pipes, hoses and nozzles installed and arranged in a manner that permits the cleaning of the milking parlour, milk house and milking equipment and utensils,
(ii) with a hose attached to an outlet separate from the sink, and
(iii) that is protected from any source of contamination to the water,
(g) has at least one properly trapped floor drain, 10 centimetres or more in diameter, which is located not less than 60 centimetres from the farm bulk tank outlet valve,
(h) has properly trapped sink drains,
(i) has floor and sink drains connected to a closed sewer pipe not less than 10 centimetres in diameter, which pipe is located under the milk house floor and which discharges into a wastewater drainage system,
(j) has adequate drainage,
(k) is equipped with a ventilation system that eliminates condensation and odours that may affect the organoleptic characteristics of the raw milk,
(l) is properly insulated and equipped with a heating system that prevents freezing and the formation of condensation inside the milk house,
(m) has a ceiling and walls that are
(i) durable, smooth, washable and made of impervious materials, and
(ii) free of indentations, loose scale, pitting and cracks,
(n) has light bulbs that are shatterproof or protected with covers,
(o) is illuminated in a manner that permits milk handling operations, inspections, and the cleaning and sanitizing of the premises and milking equipment and utensils,
(p) is equipped with a liquid soap dispenser and single service towels within close proximity of the sinks for the purpose of washing and drying hands,
(q) is equipped with a hose port in one wall that is located in close proximity to the farm bulk tank outlet and
(i) is at least 25 centimetres above the floor level of the milk house or the outside grade level whichever is higher, and
(ii) has a self-closing cover through which the hose connecting the milk tank to the farm bulk tank may pass to permit the collection of raw milk,
(r) has an apron of concrete, crushed stone, asphalt or other material approved by the Commission that
(i) is located outside an entrance to the milk house and directly below the hose port, and
(ii) is large enough to keep the hose from the milk tank clean,
(s) has a grounded exterior electrical outlet that is above the hose port and is controlled by a bipolar switch located on the interior wall of the milk house in a location accessible to the bulk tank milk grader,
(t) is maintained in a clean and sanitary condition,
(u) is maintained in good repair,
(v) is kept free of pests,
(w) has a minimal number of flies, insects and vermin, and
(x) is kept free of animals, including fowl.
(2) All exterior doors, windows and openings of a milk house shall be closed or fitted with screens or other devices to prevent the entry of pests.
(3) The exterior walls a milk house shall be covered with metal, cedar shingles or any other type of material approved by the Commission.
(4) The roof of a milk house shall be covered with metal, asphalt shingles, cedar shingles or any other type of material approved by the Commission.
(5) If the refrigeration compressor, vacuum pump of the milking system, water pump or water heater is located in a milk house, the refrigeration compressor, vacuum pump of the milking system, water heater or water pump shall be installed and operated in a manner that does not contaminate the raw milk.
Read the Milk Quality on the Province's website ↗
Made under Natural Products Act, c. N-1.2.