Code of Practice for Agricultural Environmental Management, B.C. Reg. 8/2019

Section 16

How to measure setbacks

Cite as Code of Practice for Agricultural Environmental Management, B.C. Reg. 8/2019, s. 16 · last amended July 15, 2029 · read from BC Laws on November 17, 2026

The text

(1) In this section, “high water mark” has the same meaning as in the Riparian Areas Regulation. (2) For the purpose of measuring a setback, measurements must be taken horizontally from the outer edge or limit of a structure or place where an activity occurs to the following: (a) in the case of a drinking water source (i) that is groundwater, the outer edge of the well, reservoir or other structure used to collect the water, or (ii) that is not groundwater, the top of its bank or its high water mark, as applicable; (b) in the case of a watercourse, the top of its bank or its high water mark, as applicable; (c) the property boundary. (3) Despite subsection (2), if a setback is to be measured from a diversion point, measurements must be taken in a radius from the outer edge of the end of the pipe or other structure used to pump water out of a watercourse.
Read the Code of Practice for Agricultural Environmental Management on BC Laws ↗

Made under Environmental Management Act, SBC 2003, c. 53.