Weld Repair of Aluminum Alloy Wheels Regulation, B.C. Reg. 5/97
Schedule 1
Schedule 1
Cite as Weld Repair of Aluminum Alloy Wheels Regulation, B.C. Reg. 5/97, Schedule 1 · last amended February 28, 2022 · read from BC Laws on November 17, 2026
The text
Schedule 1
[en. B.C. Reg. 40/2001, s. 6.]
Test Methods and Acceptance Criteria
for Welding Performance 1 Refer to the procedures outlined in Canadian Standards Association W47.2-M1987 standard or the GTAW or GMAW process for welding in a "flat position" of weld bead overlay, weld buildup and full penetration groove weld. 2 Refer to Canadian Standards Association W47.2-M1987 standard for a description of test methods and acceptance criteria. The welding test must be performed using one of 5083, 5086 or 6061 aluminum flat plate with an 8 mm (5/16 inch) material thickness and full penetration weld. 3 A welder must meet all of the following test standards:
Pass/Fail Test Standard Type of Test Qty Acceptance/Rejection Criteria Face bend 2 After bending, a flaw exceeding 3 mm (1/8 inch) in length is a failure. Root bend 2 After bending, a flaw exceeding 3 mm (1/8 inch) in length is a failure. Macro etch test 2 Incomplete penetration achieved through thickness of material welded is a failure. Tensile test 2 A reduction of the ultimate tensile strength of aluminum alloy is a failure. Fracture test 2 Incomplete penetration achieved through thickness of material welded is a failure.
Note: A tensile test is required for the initial performance test only and, once passed, it is not required for a subsequent re-test.
Read the Weld Repair of Aluminum Alloy Wheels Regulation on BC Laws ↗
Made under Motor Vehicle Act, RSBC 1996, c. 318.