Milk Industry Standards Regulation, B.C. Reg. 464/81
Section 58
Duties of bulk tank milk grader
Cite as Milk Industry Standards Regulation, B.C. Reg. 464/81, s. 58 · last amended March 6, 2024 · read from BC Laws on November 17, 2026
The text
(1) A person must not transfer raw milk from a farm holding tank to a tank truck unless the person is a bulk tank milk grader.
(2) A bulk tank milk grader must do all of the following when transferring raw milk from a farm holding tank to a tank truck:
(a) immediately upon entering the milk house, ensure that the bulk tank milk grader's hands are clean by washing and drying them before handling or touching any of the equipment;
(b) examine the raw milk in the farm holding tank for undesirable odours and for physical defects or other objectionable matter;
(c) if the agitator in the farm holding tank is running when the bulk tank milk grader enters the milk house
(i) record the time and permit agitation to continue for at least an additional 5 minutes, and
(ii) immediately take a sample of the raw milk when the agitation stops, as required by paragraphs (h), (i) and (j);
(d) if the agitator is not running when the bulk tank milk grader enters the milk house and if the raw milk has passed the preliminary examination required under paragraph (b), take a reading;
(e) before any reading is taken,
(i) ensure that the measuring rod is the correct one for that farm holding tank,
(ii) remove the measuring rod from the raw milk, cleanse and rinse it with hot water and thoroughly dry it with a clean tissue or paper towel,
(iii) ensure that the raw milk surface is completely still and remains so during the taking of the reading,
(iv) reinsert the measuring rod carefully and slowly, taking care not to penetrate foam,
(v) ensure that the rod is seated properly,
(vi) give the head of the rod a light tap and remove hand momentarily,
(vii) withdraw the measuring rod slowly so that any disturbance of the raw milk surface is minimized in case a remeasurement is necessary, and
(viii) read the measurement of the raw milk as indicated by the raw milk surface line to the nearest one thirty-second of an inch or the nearest millimetre without interpolating;
(f) record the measurement of the raw milk in terms of the measuring rod or gauge reading and, by reference to the conversion chart posted on the milk house wall, record the corresponding volume in litres;
(g) immediately following the recording of the measurement, take and record the temperature of the raw milk in the farm holding tank;
(h) after the raw milk has been agitated for a least 5 minutes in the farm holding tank, take a sample of not less than 100 ml obtained in approximately proportionate amounts from several locations within the tank using a sanitized dipper that has been rinsed in the raw milk prior to sampling;
(i) add the sample to an approved clearly identified pre-sanitized single use container;
(j) tightly close the sample container;
(k) take such other samples as may be required by an inspector or the dairy plant licensee to whom the raw milk is consigned;
(l) enter in triplicate on record forms the following information:
(i) the measurement and volume recorded;
(ii) the name or adequate identification of the owner of the raw milk;
(iii) the name of the dairy plant licensee purchasing the raw milk;
(iv) the time and date of pickup;
(v) the temperature of the raw milk;
(vi) the signature of the bulk tank milk grader;
(vii) where appropriate, remarks concerning any unusual occurrence or situation during the course of the pickup;
(m) leave the raw milk in the farm holding tank if, in the bulk tank milk grader's opinion, the raw milk
(i) is abnormal in odour or contains excessive sediment, objectionable matter or physical defects of any kind not consistent with good quality milk, or
(ii) would, if transferred into the tank truck, be detrimental to the raw milk in the tank truck or to subsequent transfers of other raw milk into the tank truck;
(m.1) leave the raw milk in the farm holding tank if
(i) the temperature of the raw milk is below 0°C or above 4°C,
(ii) the bulk tank milk grader is unable to sample the raw milk in accordance with this section, or
(iii) the dairy farm does not have a certificate of approval or the certificate is suspended;
(n) Repealed. [B.C. Reg. 37/2012, s. 18 (c).]
(o) after transferring the raw milk from the farm holding tank and disconnecting the hose,
(i) rinse the inner surfaces of all parts of the farm holding tank with lukewarm water,
(ii) remove litter of any kind resulting from the raw milk pickup, and
(iii) wash and rinse down the drain any spillages on the outer surface of the farm holding tank or the milk house floor;
(p) switch off the lights, and the compressor in the case of a direct expansion farm holding tank, when leaving the milk house and close the door and the hose port of the milk house;
(q) carefully store and transport samples, maintaining them at a temperature between freezing point and 4C until they are delivered to a responsible person at the dairy plant to which the raw milk is consigned;
(r) where samples of the raw milk are not obtained, notify the producer of the raw milk and the management of the dairy plant to which the raw milk is consigned, giving the reasons for not obtaining samples.
(3) If a bulk milk tank grader refuses to transfer raw milk under subsection (2), the bulk milk tank grader must
(a) make a record of the reason why the raw milk was refused,
(b) provide the dairy farmer with a copy of the record,
(c) retain a copy of the record for a period of at least 3 months,
(d) on request of an inspector, provide the record to the inspector, and
(e) identify the raw milk as not being suitable for human consumption.
Read the Milk Industry Standards Regulation on BC Laws ↗
Made under Milk Industry Act, RSBC 1996, c. 289.