Milk Industry Standards Regulation, B.C. Reg. 464/81
Section 40
Farm holding tanks, measuring rods
Cite as Milk Industry Standards Regulation, B.C. Reg. 464/81, s. 40 · last amended March 6, 2024 · read from BC Laws on November 17, 2026
The text
(1) All measuring rods used to measure raw milk in farm holding tanks shall be of stainless steel or equivalent.
(2) Every measuring rod and direct reading gauge shall be graduated as follows:
(a) graduation marks on the measuring rod shall be plainly milled or stamped
(i) in inches, and in halves, quarters, eighths, sixteenths and thirty-seconds of an inch, or
(ii) in centimetres and millimetres;
(b) graduation marks shall be milled or stamped so that they may be easily read and distinguished and, where the rod or gauge is graduated in centimetres and millimetres, so that every fifth millimetre of graduation is conspicuous;
(c) numerals designating inches or centimetres that are marked on the rod or gauge shall increase numerically from the bottom upwards;
(d) numerals designating thirty-seconds of an inch shall not be less frequent than at quarter-inch intervals.
(3) The measuring rod shall be fixed in the holder at the gauge point of the tank so that
(a) it hangs vertically, and
(b) the maximum swing at the lower end of the rod when at measuring level does not exceed
(i) 18 mm for a rod 750 mm or less in length,
(ii) 30 mm for a rod over 750 mm but less than 1 500 mm in length, and
(iii) 36 mm for a rod over 1 500 mm in length.
Read the Milk Industry Standards Regulation on BC Laws ↗
Made under Milk Industry Act, RSBC 1996, c. 289.