Milk Industry Standards Regulation, B.C. Reg. 464/81
Section 36
Farm holding tanks, construction
Cite as Milk Industry Standards Regulation, B.C. Reg. 464/81, s. 36 · last amended March 6, 2024 · read from BC Laws on November 17, 2026
The text
(1) Every farm holding tank shall be of a type that conforms to 3A Standards.
(2) Every farm holding tank shall be constructed and installed so that measurements of the contents taken in accordance with this Part do not exceed the limits of tolerance set out in the following table: Volume of Contents
in litres Limits of Tolerance
in litres 0 − 1 000 2 1 001 − 2 000 3 2 001 − 3 000 4 3 001 − 4 500 5 4 501 − 6 000 6 6 001 − 8 000 7 8 001 − 10 000 8 10 001 − 12 000 9 12 001 − 14 000 10 14 001 − 16 000 11 Over 16 000 12
(3) All farm holding tanks shall be constructed so that accurate measurements of the contents may be made at one point in the tank by means of a measuring rod that conforms to section 40 or by means of a direct reading gauge.
(4) Farm holding tanks shall be firmly fixed to a properly reinforced concrete floor to prevent any movement likely to interfere with the accuracy of measurement.
(5) Every farm holding tank shall be permanently marked at the gauge point where the measuring rod is positioned for calibration and all measurements of raw milk shall be taken from this point.
(6) All farm holding tanks shall be installed so that there is a positive internal slope toward the outlet valve to allow rapid, uninterrupted and complete drainage of the contents.
(7) Every farm holding tank that is 2 500 litres or more in volume shall be provided with an access ladder to facilitate measuring and sampling the contents.
Read the Milk Industry Standards Regulation on BC Laws ↗
Made under Milk Industry Act, RSBC 1996, c. 289.