Milk Industry Standards Regulation, B.C. Reg. 464/81

Section 103

H.T.S.T. pasteurization — general

Cite as Milk Industry Standards Regulation, B.C. Reg. 464/81, s. 103 · last amended March 6, 2024 · read from BC Laws on November 17, 2026

The text

(1) H.T.S.T. pasteurizers shall be provided with (a) indicating and recording thermometers, and (b) a recorder controller with a built in recording thermometer that is (i) designed for sealing, (ii) fitted with an additional pen to record on the chart a full record of the time during which the dairy product is travelling in a forward flow direction, and (iii) designed so that the interval between the moment of power cut off during descending temperatures and the moment where the forward flow of dairy product ceases does not exceed one second, (c) a flow diversion valve, (d) a holding section that is (i) designed and installed in a manner to cause a continuous upward flow of dairy product from the inlet to the flow diversion valve, and (ii) equipped, when required, with the necessary fittings for checking the holding time by means of saline solution, (e) a milk pump that is (i) located at the raw dairy product inlet of the final heating chamber, and (ii) designed so that it may be set not to exceed a predetermined speed and sealed, and (f) where necessary, a pipe line on the diversion outlet side of the flow diversion valve that is so restricted as to cause at least as much back pressure on the dairy product in diverted flow as when in forward flow. (2) When in operation, the pressure of the pasteurized dairy product in the regenerative section of the pasteurizer shall at all times be greater than the pressure of the raw dairy product in the same section. (3) No equipment other than the pump described in subsection (1) (e) shall be used to control the rate of the flow of the dairy product through the final heating section of the pasteurizer.
Read the Milk Industry Standards Regulation on BC Laws ↗

Made under Milk Industry Act, RSBC 1996, c. 289.