Groundwater Protection Regulation, B.C. Reg. 39/2016
Section 42
Custom-designed well caps and well covers
Cite as Groundwater Protection Regulation, B.C. Reg. 39/2016, s. 42 · last amended December 1, 2022 · read from BC Laws on November 17, 2026
The text
(1) If it is not practicable for the owner of a well referred to in section 39 (2) [maintenance and attachment of well caps or steel plates] or 41 (2) to attach a well cap or install a well cover that meets the requirements of this Part, the well owner must engage a qualified well driller, qualified well pump installer or professional to design and attach an effective well cap or design and install an effective well cover.
(2) For the purposes of subsection (1), a well cap is effective if it does all of the following:
(a) prevents direct and unintended entry into the well of
(i) any water at the surface of the ground, including floodwater and ponded water, and
(ii) any foreign matter;
(b) prevents persons or animals from entering the well;
(c) stops or brings under control the flow of water from a flowing artesian well.
(3) For the purposes of subsection (1), a well cover is effective if the requirements of subsection (2) (a) and (b) are met.
(4) The owner of a well must ensure that a well cap attached or well cover installed under this section is maintained in good operating condition.
Read the Groundwater Protection Regulation on BC Laws ↗
Made under Water Sustainability Act, SBC 2014, c. 15.