Commercial Transport Regulations, B.C. Reg. 30/78
Section 1.01
Interpretation for regulation
Cite as Commercial Transport Regulations, B.C. Reg. 30/78, s. 1.01 · last amended August 5, 2025 · read from BC Laws on November 17, 2026
The text
In these regulations, unless the context otherwise requires:
“A dolly” means a trailer converter dolly that is towed from a single hitch located on the centre line of the towing vehicle;
“A train” means a combination of vehicles composed of a truck tractor, a semi-trailer and either
(a) an A dolly and a semi-trailer, or
(b) a full trailer;
“Act” means the Commercial Transport Act;
“air deflector” means a device attached to the front of a vehicle designed to reduce air resistance around the vehicle or load but no part of which is used to carry a load;
“anti splash and spray device” means a device that is attached to a vehicle and is designed to control or reduce the amount of water thrown up by the moving wheels of the vehicle;
“articulation point” means
(a) the vertical axis of the kingpin in a fifth wheel coupler and kingpin assembly,
(b) the vertical axis through the centre of a lunette eye in a pintle hook and lunette eye assembly, or
(c) the vertical axis through the centre of rotation of a turntable or other similar device
that allows the vehicles in a combination of vehicles to rotate in the horizontal plane relative to one another;
“automatic axle lift device” means a device that is designed
(a) to lift or otherwise remove the tires of an unloaded trailer's axle from contact with the road surface, and
(b) to automatically lower the tires to the road surface if a load is placed in the trailer;
“axle” means a structure that is wholly in the same or approximately the same transverse plane and that is supported by wheels on which or with which it revolves;
“axle spread” means the longitudinal distance between the extreme axle centres of the axle unit;
“axle track width” means the overall width of an axle across the outside faces of the tires measured at any point above the lowest point of the rim;
“axle unit” means
(a) a single axle,
(b) a tandem axle, or
(c) a tridem axle;
“axle unit weight” means the weight transmitted to the highway by an axle unit;
“B train” means a combination of vehicles composed of a truck tractor and a semi-trailer, followed by another semi-trailer attached to the first semi-trailer by means of a fifth wheel coupler mounted on the first semi-trailer, within the axle spread of the first semi-trailer or not located more than 0.3 m behind the centre of the last axle;
“bed truck” means a truck tractor equipped with a cargo carrying deck and a winch that is used for self loading and that is located behind the cab;
“box length” means the longitudinal dimension from the front of the cargo carrying unit to its rear, exclusive of any extension in the length caused by auxiliary equipment or machinery at the front that is not designed for the transportation of goods;
“C converter dolly” means a trailer converter dolly that has a rigid frame in the horizontal plane and is towed from 2 hitches located in a horizontal transverse line on the towing unit, which preclude any rotation in the horizontal plane about the hitch points, and that satisfy all requirements of the Canadian Motor Vehicle Safety Standards applicable to such devices;
“C dolly” means a trailer converter dolly which is not an A dolly;
“C train” means a combination of vehicles composed of a truck tractor and a semi-trailer, followed by another semi-trailer attached to the first semi-trailer by the means of a C dolly or C converter dolly;
“clearance lamp” means a clearance lamp required under Division 4 of the Motor Vehicle Act Regulations, B.C. Reg. 26/58;
“dangerous goods placard” means a placard required under the Transport of Dangerous Goods Act or the Transportation of Dangerous Goods Act (Canada) and includes a holder for that placard;
“daylight” means the time between 1/2 hour before sunrise and 1/2 hour after sunset;
“dog logger” means a vehicle or device which is attached to the rear of a pole trailer and shares the load through an articulation point;
“drawbar” means a structural member of a full trailer or trailer converter dolly that includes a device for the purpose of coupling with a trailer hitch or fifth wheel;
“drawbar length” means the longitudinal distance from the centre of the hole in the fifth wheel of a converter dolly or turntable center to the center of the hitching device on the towing vehicle;
“drive axle” means an axle that is or may be connected to the power source of a motor vehicle and transmits tractive power to the wheels;
“effective overhang” means the longitudinal distance from the turn centre of the full trailer, pony trailer, semi-trailer, truck or intercity bus to the rearmost point of the vehicle including load;
“farm vehicle” means a commercial vehicle owned or leased, and operated, by a farmer, rancher or market gardener, the use of which is confined to purposes connected with the farmer's farm, rancher's ranch or market gardener's market garden, including use for pleasure, and that is not used in connection with any other business in which the farmer, rancher or market gardener may be engaged;
“fifth wheel coupler” means a device that is mounted on the vehicle chassis and that consists of a skid plate, associated mounting brackets and latching mechanism that couples or connects to a kingpin located on the other vehicle or component;
“full trailer” means a vehicle without motive power that is designed to be towed by another vehicle and is so designed that the whole of its weight and load is carried on its own axles and includes a combination consisting of a semi-trailer and trailer converter dolly;
“gross weight, all axles” means the sum of the individual axle weights of all the axles of a vehicle or combination of vehicles;
“gross weight, group of axles” means the sum of the gross axle weights of all the axles comprising the group of axles;
“gross weight, single axle” means the gross weight carried by a single axle and transmitted to the road by the wheels of that axle;
“group of axles” means any 2 or more successive axles on a vehicle or combination of vehicles;
“highway” includes every highway within the meaning of the Transportation Act, and every road, street, lane or right of way designed or intended for or used by the general public for the passage of vehicles, and every private place or passageway to which the public, for the purpose of parking or servicing of vehicles, has access or is invited;
“hitch offset” means the longitudinal distance from the truck or trailer turn centre to the articulation point of the hitch used to tow the following vehicle;
“horsepower” means the gross horsepower of the engines of the towing vehicle as customarily rated by the manufacturer;
“interaxle spacing” means the longitudinal distance separating 2 axle units as determined from the centres of each of the axles that is the closest to the other axle unit;
“intercity bus” means a vehicle designed to carry more than 15 passengers and equipped with facilities to allow extended travel without stopping;
“jeep” means a semi-trailer that is designed to be attached between a truck tractor and another semi-trailer, so as to distribute the load of the other semi-trailer between the axles of the jeep and axles of the truck tractor;
“length (full trailer)” means the longitudinal dimension from the front of the full trailer to its rearmost point and does not include the drawbar;
“length (pony trailer)” means the longitudinal dimension from the centre of the hitching device of the pony trailer to its rearmost point;
“lift axle” means an axle equipped or designed with any device to raise or lock the axle in a raised position;
“load securement device” means
(a) a tie down, binder, lock, chain, cable, belt, rope, winch, cinch, hook or covering, or
(b) a door handle, door lock, door hinge or bunk cable guide required under Division 35 of the Motor Vehicle Act Regulations;
“logging truck” means a truck, truck and trailer combination or truck tractor and trailer combination used to haul, in their natural state, green felled or bucked logs or poles;
“lowbed semi-trailer” means a semi-trailer that has a depressed deck area;
“manufacturer” means
(a) in the case of a vehicle, the company whose name appears on the statement of compliance and to which a National Safety Mark has been issued, and
(b) in the case of a tire, the company whose name appears in the side wall of the tire;
“overall length” means the greatest overall longitudinal dimension of a vehicle or combination of vehicles including load;
“permanently mounted equipment” means a
(a) heavy duty crane mounted on a truck tractor or truck,
(b) hydraulic or main-engine winch, power-driven off the engine,
(c) chassis-mounted rotating ready-mix concrete drum,
(d) dump box with tilt cylinders or a multi-stage tilt cylinder mounted behind the cab,
(e) liquid tank if 100% of a liquid tanker truck's payload and capacity consists of a liquid load, or
(f) liquid tank associated with hydro-vac equipment if it is designed and used to excavate trenches and holes hydraulically and vacuum the loosened material into the liquid tank, but does not include conventional vacuum truck equipment;
“pole trailer” means a vehicle without motive power designed to be drawn by another vehicle and to be attached to the towing vehicle by means of a reach or pole, or by being boomed to the other vehicle, and which is ordinarily used for transporting long or irregularly shaped loads such as logs, poles, pipes or structural members;
“pony trailer” means a vehicle that is designed to be towed by a truck by means of a rigidly attached structure and is so designed and used that the preponderance of its weight and load is carried on one axle unit of the vehicle;
“quarterly licence” means a licence issued under section 5.02;
“reefer van” means a trailer or semi-trailer equipped with either a refrigeration unit or a heating unit or both;
“self steering axle” means an axle on which the wheels turn left and right on one or more essentially vertical axes but their turning is not controlled by means of the steering wheel in the operator's compartment;
“semi-trailer” means a vehicle without motive power, designed so that a substantial part of its weight and load rests on and is carried by the truck, truck tractor, another semi-trailer or a trailer converter dolly to which it is attached by a fifth wheel coupler;
“single axle” means one axle or 2 consecutive axles having an axle spread of less than 1.0 m;
“steering axle” means an axle on which the wheels turn left and right on one or more essentially vertical axes and their turning is controlled by, and in direct proportion to, the rotation of the steering wheel in the operator's compartment;
“tandem axle” means 2 or more equally spaced consecutive axles, having an axle spread of not less than 1.0 m nor more than 1.85 m;
“tandem drive axle” means a tandem axle that is connected to the power source of a motor vehicle and that transmits tractive power to all wheels;
“towing dolly” means a trailer that is designed exclusively to carry one axle of a motor vehicle for the purpose of towing the motor vehicle behind another motor vehicle;
“trailer converter dolly” means a vehicle unit which consists of one or more axles, a fifth wheel and a drawbar, and is used to convert a semi-trailer to a full trailer;
“trailer wheelbase” means the longitudinal distance from the centre of the kingpin of a semi-trailer, or the centre of the turntable of a full trailer, or the centre of the hitching device on a pony trailer, to the trailer turn centre;
“tridem axle” means 3 equally spaced consecutive axles, having an axle spread of not less than 2.4 m nor more than 3.7 m on TAC semi-trailers and trailers or having an axle spread of not less than 2.4 m nor more than 2.5 m on TAC pony trailers;
“tridem drive axle” means 3 equally spaced consecutive engine-driven axles having an axle spread of not less than 2.4 m and not more than 2.8 m, and an axle track width of not less than 2.4 m and not more than 2.6 m for axles that are equipped with either dual wheels or tires, or an axle track width of not less than 2.45 m and not more than 2.6 m for axles that are equipped with wide base single tires on each track;
“tridem pole trailer” means a pole trailer which contains a tridem axle in which all axles are fixed to a common structure;
“tridem tractor” means a truck tractor that is equipped with single or tandem steering axles and a tridem drive axle;
“truck” means a motor vehicle, other than a bus, that is either permanently fitted with special equipment or is designed to and normally used to carry a load, and that may operate as a single unit or may pull a full trailer or pony trailer;
“truck tractor” means a motor vehicle, having a net weight of more than 4 000 kg, that is equipped with a fifth-wheel coupler or a centre rotatable log bunk mounted on a bolster affixed to the vehicle's chassis, and includes an auto carrier with an underslung fifth wheel coupler and a truck tractor with a load box;
“turn centre” means the geometric centre of the axle unit on a semi-trailer or pony trailer or the rear axle unit on a truck, truck tractor, full trailer or bus;
“vehicle” means a commercial vehicle, trailer or semi-trailer as defined in the Act;
“wheelbase” means the longitudinal distance from the centre of the front steering axle to the geometric centre of the drive axle;
“wide base single tire” means a tire that has a tire width of 445 mm or larger and a bead diameter of 49.5 cm or larger and that meets the requirements of the Motor Vehicle Tire Safety Regulations (Canada);
“width of tire” means, with respect to rubber tires, the width of the tire as customarily measured and rated by manufacturers of motor vehicles and tires and, with respect to metal tires or solid rubber tires, the transverse width of the outer circumference of the metal tire or solid rubber tire.
Read the Commercial Transport Regulations on BC Laws ↗
Made under Commercial Transport Act, RSBC 1996, c. 58.