Motor Vehicle Act Regulations, B.C. Reg. 26/58

Section 7E.04

Prohibition against tampering technology

Cite as Motor Vehicle Act Regulations, B.C. Reg. 26/58, s. 7E.04 · last amended October 19, 2027 · read from BC Laws on November 17, 2026

The text

(1) In this section “tampering technology”, in relation to a heavy commercial vehicle, means technology, equipment or any other thing to which either of the following applies: (a) the technology, equipment or thing is designed to disguise the fact that (i) the vehicle is not equipped with a speed limiter, (ii) the speed limiter is not activated as required under section 146.1 (2) (b) [speed limiters required for certain commercial vehicles] of the Act, (iii) the speed limiter is not set to the maximum rate of speed prescribed by section 7E.02 [maximum speed setting for speed limiters] of this regulation, or (iv) the vehicle or speed limiter does not meet a requirement set out in section 7E.03 [requirements under section 146.1 (2) (d) of Act] of this regulation; (b) the technology, equipment or thing causes inaccurate information to be transmitted to the vehicle's electronic control module, including, without limitation, inaccurate information with respect to (i) the vehicle's rate of speed, or (ii) the revolutions per minute at which the vehicle's engine is operating. (2) A person must not drive or operate a heavy commercial vehicle on a highway if tampering technology (a) is in or on the vehicle, or (b) is otherwise interacting with the vehicle's speed limiter.
Read the Motor Vehicle Act Regulations on BC Laws ↗

Made under Motor Vehicle Act, RSBC 1996, c. 318.