Motor Vehicle Act Regulations, B.C. Reg. 26/58

Section 35.05

Transporting logs or poles

Cite as Motor Vehicle Act Regulations, B.C. Reg. 26/58, s. 35.05 · last amended October 19, 2027 · read from BC Laws on November 17, 2026

The text

(1) In this section: “bunk lash” means the amount of free play caused by the vertical gap between the slipper supports and the bunk rub shoes, measured when the log bunk is perpendicular to the longitudinal axis of the pole trailer and the trailer is fully loaded; “spring lash” means the amount of free play in leaf type suspensions caused by the vertical gap between the main spring leaf and the rebound constraints or slippers. (2) A person must not drive or operate on a highway a logging truck, a truck or a truck tractor and trailer combination with a flat load deck while the vehicle is transporting a load of logs or poles or both that are longer than 2.6 m placed in the longitudinal axis with the vehicle or vehicle combination unless the vehicle is (a) equipped with the same bunk and stake assembly, unmodified, that it was equipped with at the time it was sold as a new vehicle and bears the National Safety Mark under the Motor Vehicle Safety Act (Canada) and the regulations made under it, or (b) not equipped and marked as described in paragraph (a) but is equipped with bunks and stake assemblies that meet the requirements of subsection (3) and are of adequate design and construction to contain the load. (3) For the purpose of subsection (2) (b), (a) stake extensions must be securely attached to the stakes, (b) stakes, together with their stake extensions, must form an angle of 90 or less with the bunk cross member, (c) stakes must be secured to the bunk cross member or to the trailer's side flanges or rub rails (i) by a method approved by a professional engineer, (ii) by a pin and closed loop stake lines consisting of wire rope at least 22 mm in diameter, or (iii) with properly welded gussets of adequate strength, (d) bunk lash must not exceed 5 mm when the pole trailer is fully loaded, and (e) log bunks carrying logs or poles must be securely attached to the structurally adequate integral part of the frame of the truck or trailer by nuts and bolts, retaining pins, chains or by welding. (4) If the logging truck includes a tridem pole trailer, (a) the trailer bunk centreline must be located at a point forward of the longitudinal centre of the tridem axle group, and (b) the trailer, if equipped with spring suspension, must not have any spring lash in excess of 5 mm when in a loaded state. (5) Pole trailers manufactured after January 1, 1993 and equipped with adjustable reaches must have welds, bolts, stops or some other positive means other than a friction clamp to prevent separation between any reach sections.
Read the Motor Vehicle Act Regulations on BC Laws ↗

Made under Motor Vehicle Act, RSBC 1996, c. 318.