Safety Standards Act, SBC 2003, c. 39
Section 68
Alteration of regulated products
Cite as Safety Standards Act, SBC 2003, c. 39, s. 68 · read from BC Laws on November 17, 2026
The text
(1) A person must not alter a regulated product if the alteration would or is likely to
(a) result in the product ceasing to meet the requirements of the regulations, or
(b) result in the product ceasing to meet the standards
(i) required to be met by the certification agency, or any successor of that agency, that authorized the use of a certification mark for the regulated product, or
(ii) applied to that regulated product by a provincial safety manager in issuing an approval under section 10.
(2) If an alteration to a regulated product is permitted under subsection (1), a person must not do the alteration unless that person is
(a) a licensed contractor,
(b) authorized to do so under this Act, or
(c) approved by the appropriate safety manager if the safety manager is satisfied that the person is capable of safely doing the alteration.
Read the Safety Standards Act on BC Laws ↗