Marine Machinery Regulations, SOR/90-264

Section 18

Cite as Marine Machinery Regulations, SOR/90-264, s. 18 · current to July 24, 2025 · regulation last amended December 20, 2023

Statute Watch

Get an alert when a bill in Parliament would change this section, and every time it moves.

The text

(1) The marking referred to in section 17 shall be conspicuous and not readily effaced, covered or removed, and shall be located (a) in the case of a hot-water boiler or a steam boiler, adjacent to an access or visual inspection opening; (b) in the case of an unfired pressure vessel, on an end plate; (c) in the case of a shaft, on the flange rim; (d) in the case of a propeller, on the hub; and (e) in the case of any other component, adjacent to the manufacturer’s permanent identification marking. (2) Where a component cannot be marked on a location referred to in subsection (1) because marking on the location would be physically impossible or unsafe or the marking would not be readily visible, the inspector may accept another suitable location for the marking.
Read the Marine Machinery Regulations on the Justice Laws Website ↗

Made under Canada Shipping Act, 2001, S.C. 2001, c. 26.

Bills in Parliament that would change this section 0

No bill we hold would amend or repeal this section.