Vessel Construction and Equipment Regulations, SOR/2023-257
Section 301
Requirements
Cite as Vessel Construction and Equipment Regulations, SOR/2023-257, s. 301 · current to July 24, 2025 · regulation last amended December 20, 2023
Statute Watch
Get an alert when a bill in Parliament would change this section, and every time it moves.
The text
(1) A vessel that is constructed or converted for the purposes of towing must comply with the following requirements:
(a) its towing equipment must be accompanied by manufacturer test certificates that are kept on board and that indicate the safe working load of the equipment;
(b) the towing winch, towing hook, towline emergency release and the towline must be selected with an adequate safety factor taking into account the appropriate design load specified in the recommended practices and standards for the towing operations;
(c) its towing equipment and towline emergency release must be maintained in accordance with the manufacturer’s instructions;
(d) the towing equipment manuals must be kept on board;
(e) the towing equipment must have clear operating instructions, in English or French, depending on the working language of the vessel, located near all control positions;
(f) the towline emergency release must have clear operating instructions, in English or French, depending on the working language of the vessel, located near it;
(g) in the case of a vessel on which a towline is attached to a towing winch or to a hook, the vessel must have a towline emergency release
(i) that can operate in all conditions,
(ii) that can be activated at each local control position and can be remotely operated at each steering position,
(iii) that is independent of the main source of electrical power, and
(iv) the controls for which are immediately identifiable;
(h) the local control and steering positions referred to in subparagraph (g)(ii) must be well illuminated and compatible in design and configuration with the towline emergency release mechanism;
(i) each steering position must be connected to the towing winch control position by a two-way voice communication system;
(j) if the towing winch can be remotely controlled from more than one position, the vessel must be fitted with an arrangement that prevents more than one position from exercising control at any one time;
(k) each towing winch control must be fitted with a safeguard to prevent the inadvertent operation of the control;
(l) a towing winch must not be fitted with a ratchet device that could prevent the winch from paying out the towline;
(m) if the towline is attached to a bollard or to bitts, the vessel must have a mechanical arrangement that is able to sever or release the towline immediately;
(n) in the case of a vessel that is fitted with towing pins on the counter, the pins must be power-operated; and
(o) the control position for any power-operated towing pins on a vessel must be forward of the point of tow and the pins must be clearly visible from the control position.
(2) A vessel that is constructed or converted for the purposes of towing must not undertake a towing operation unless the vessel’s bollard pull has been assessed and determined to be adequate for the operation in accordance with the recommended practices and standards and that assessment and determination are documented.
Read the Vessel Construction and Equipment Regulations on the Justice Laws Website ↗
Made under Canada Labour Code, R.S.C. 1985, c. L-2; Canada Shipping Act, 2001, S.C. 2001, c. 26; Arctic Waters Pollution Prevention Act, R.S.C. 1985, c. A-12.
Bills in Parliament that would change this section 0
No bill we hold would amend or repeal this section.