Glass Doors and Enclosures Regulations, SOR/2016-174
Section 2
Requirements
Cite as Glass Doors and Enclosures Regulations, SOR/2016-174, s. 2 · current to July 24, 2025 · regulation last amended June 22, 2016
Statute Watch
Get an alert when a bill in Parliament would change this section, and every time it moves.
The text
The glass that is contained in a glass door or enclosure must be a safety glass set out in column 1 of the table to this section that, when tested in accordance with the applicable test referred to in column 2, meets the requirement for that test set out in column 3.Column 1Column 2Column 3ItemSafety glassTestRequirement1Laminated glass(1) Boiling water test in paragraph 7.2.2 of the safety glass standard(1) No bubbles or other defects develop beyond 12 mm from the outer edge of the glass or from any crack that develops.(2) Impact test in paragraph 7.2.3 of the safety glass standard(2) No opening occurs that would permit free passage of a 75 mm diameter steel sphere.2Tempered glassImpact test in paragraph 7.2.3 of the safety glass standardIf breakage of the test specimen occurs, the total mass of the 10 largest fragments does not exceed the mass of 6 500 mm2 of the unbroken test specimen.3Wired glassImpact test in paragraph 8.2.2 of the wired safety glass standard(a) No opening occurs that would permit free passage of a 75 mm diameter steel sphere.(b) The glass adjacent to each crack extending from the impact area is held in place by the reinforcing material.(c) Small fragments of glass from both sides of the test specimen at or immediately around the point of impact may become detached, but no piece loosens or detaches from any other part of the test specimen.
Read the Glass Doors and Enclosures Regulations on the Justice Laws Website ↗
Made under Canada Consumer Product Safety Act, S.C. 2010, c. 21.
Bills in Parliament that would change this section 0
No bill we hold would amend or repeal this section.