Motor Vehicle Tire Safety Regulations, SOR/2013-198

Section 7

National Safety Mark

Cite as Motor Vehicle Tire Safety Regulations, SOR/2013-198, s. 7 · current to July 24, 2025 · regulation last amended January 1, 2025

Statute Watch

Get an alert when a bill in Parliament would change this section, and every time it moves.

The text

(1) For the purposes of these Regulations, the symbol set out in Figure 1 of Schedule 1 is prescribed as the national safety mark. (2) For the purposes of subsection 3(2) of the Act, on application by a company, the Minister may, in the form set out in Schedule 2, authorize the company to apply the national safety mark to a tire. (3) For the purposes of subsection 3(2) of the Act, when a company applies the national safety mark to a tire, the company must (a) reproduce the symbol set out in Figure 1 of Schedule 1 with the minimum height specified in Figure 3 of that Schedule; and (b) permanently mould the symbol into or onto one sidewall of the tire (i) in one of the places shown in Figure 3 of Schedule 1, and (ii) at a depth or height of not less than 0.5 mm and not more than 1 mm as measured from the immediate surrounding surface of the sidewall.
Read the Motor Vehicle Tire Safety Regulations on the Justice Laws Website ↗

Made under Motor Vehicle Safety Act, S.C. 1993, c. 16.

Bills in Parliament that would change this section 0

No bill we hold would amend or repeal this section.