Motor Vehicle Restraint Systems and Booster Seats Safety Regulations, SOR/2010-90
Section 217
Rear-facing child restraint system
Cite as Motor Vehicle Restraint Systems and Booster Seats Safety Regulations, SOR/2010-90, s. 217 · current to July 24, 2025 · regulation last amended January 1, 2025
Statute Watch
Get an alert when a bill in Parliament would change this section, and every time it moves.
The text
A rear-facing child restraint system that is subjected to a dynamic test in accordance with section 4 of Test Method 213 must, when in any adjustment position for which there is no warning under subparagraph 218(1)(e)(iii),
(a) retain the torso of the anthropomorphic test device within the restraint system, and not allow any portion of the target points on either side of the device’s head, located on the transverse axis passing through the centre of mass of the device’s head and perpendicular to the head’s midsagittal plane, to pass at any time, during or immediately after the test, either through the transverse orthogonal planes formed by the extension of the seat back frontal surface plane of the restraint system and by the plane that passes through the uppermost point of the restraint system, as shown in Figure 7 of Schedule 7, or through the vertical transverse plane passing through point X on the standard seat assembly, as shown in Figure 8 of Schedule 7; and
(b) not allow the angle between the vertical and the back and head support surface, measured 240 mm above the seating surface, to be more than 70° at any time during the test.
Read the Motor Vehicle Restraint Systems and Booster Seats Safety Regulations on the Justice Laws Website ↗
Made under Motor Vehicle Safety Act, S.C. 1993, c. 16.
Bills in Parliament that would change this section 0
No bill we hold would amend or repeal this section.