Canada Oil and Gas Drilling and Production Regulations, C.R.C., c. 1517

Section 90

Cite as Canada Oil and Gas Drilling and Production Regulations, C.R.C., c. 1517, s. 90 · current to July 24, 2025 · regulation last amended March 22, 2006

Statute Watch

Get an alert when a bill in Parliament would change this section, and every time it moves.

The text

(1) On both sides of the draw works, guards of heavy metal shall be provided for all drive sprockets and chains, and such guards shall be strong enough to withstand the shock of breaking chains and shall be installed so that workmen cannot come in contact with the moving parts. (2) The guard for the low gear drum driven sprockets and chain next to the driller shall be flanged with a steel plate so that a breaking chain cannot hit the driller or foul the brake lever. (3) On every chain-driven rig, the pinion shaft, the couplings and the bevel gear shall be guarded with metal shields. (4) On every shaft-driven rig, the drive pinion, the shaft, the coupling and the bevel gears shall be guarded with metal shields. (5) The pump end of every rig hose shall be securely fastened to the derrick and the swivel end of such hose shall be securely fastened to the swivel housing with a safety chain or wire cable. (6) The key seat and projecting key on every cathead shall be covered with a smooth thimble. (7) Every cathead shall be provided with an adequate guard to separate the first turn of the catline. (8) The tops and outer sides of the hoisting drum brake flanges shall be guarded by a steel plate of a thickness not less than 1/8 inch, and these guards shall be installed with a minimum working clearance from the brake and shall be securely bolted in place. (9) All rotary rig tongs shall be provided with two separate wire-rope safety cables of a diameter not less than 5/8 inch. (10) Every steam-driven drilling engine shall, in addition to the usual steam-control valve, be equipped with a quick closing steam valve to which is attached an extension handle of sufficient length so as to be readily available to the driller while at the controls of the rig. (11) The rotary table shall not be used for final making up or initial breaking out of drill pipe. (12) Where practicable, a locking device shall be installed on all control levers. (13) The eye connection of all safety cables shall be securely fastened with at least three U type clamps. (14) The suction pit shall be equipped on its outer edge with a two-rail railing of adequate height.
Read the Canada Oil and Gas Drilling and Production Regulations on the Justice Laws Website ↗

Made under Territorial Lands Act, R.S.C. 1985, c. T-7.

Bills in Parliament that would change this section 0

No bill we hold would amend or repeal this section.